The study of wood as a renewable material and organic material is what is known as wood science. In other words, the term wood science can also be known as wood technology. To be able to study wood it has to be compared to other products. Materials properties, ease of it being worked on and its value are among the few properties which are compared against those of wood and other materials. The many Merits of timber and these technologies improve wood to be superior over other products. The wide range of products where wood can be used is just one of the many advantages that give wood an upper hand over other products. Once a tree has been cut down another can be planted in the same spot. The other merit is that a part of the harvested material is at the same time used as energy to produce the product.
The good appearance of your timber made structure cannot be guaranteed if protection of the timber is not done. The biggest threat to wood being moisture and insects has to be kept away from the wood. The rotting and decay of the timber products are caused by the moisture and the insects. There are many ways timber is treated among them being the ACQ in other words alkaline copper Quaternary. This is a copper-based preservative that is applied to the wood for protection. As effective as this preservative, it has some downside to its use. The chemical is highly corrosive to most metals, the chemical corrodes away galvanized fasteners and therefore only stainless steel is used. The concentration of the chemical that will be used to treat a piece of wood will depend on the where it is going to be used and the molecular structure of the wood. Timber being used around a water body will be dipped in a more saturated fluid than that being used above ground.
The use of copper metal is another method of wood treatment that is fast being accepted. This method is being accepted fast because is friendly to wooden fasteners. Micronized copper wood preservative is the correct term to refer this type of preservation. The copper metal is applied to the wood as small microscopic particles injected into the wood at high pressure. The process eliminates the need to dissolve the copper as is done in earlier copper-based preservatives. This process is highly effective and the wood properties and heightened. The timber treated in this way is used in both outdoor and indoor frames that last very long.
Termites cannot eat through timber treated through this method. It is not corrosive to metals used in together with the product. Extensive research over a period of 10 years has proven the effectiveness of this science as one of the best wood preservation methods.